Easy Guide on How to Fix a Garbage Disposal Leak from the Bottom and Reset Button

A garbage disposal unit’s leaking issue usually goes undetected until you started to notice audible dripping noise, rotten-smelling puddle, or scrutiny sopping cabinet. Finding the leak problem’s cause to fix it can be frustrating because the leak can originate from various components in the system.

Luckily, there is a way to repair the leak on your own if you have investigated the exact leak source location and the cause.

Read also : How to Fix Issues of Garbage Disposal Won’t Turn On

The worst can happen if it turns out that you have to replace the unit and install a new one. In the meantime, read about how to fix a garbage disposal leak detail below.

How to Fix a Garbage Disposal Leak

The first thing you need to observe in case of a leaking disposal unit is the gasket. The gasket is the top rim part with rubber. Doing gasket replacement is easy – all you have to do is purchase the replacement gasket in your local hardware store.

How to Fix a Garbage Disposal Leak

Here are the steps on how to fix a garbage disposal leak due to the gasket issue.

  1. Disengage the drain and then took the cord of your disposal unit off. Remove the drain hose as well if you have a dishwasher.
  2. Unlock the device by capture the sides of the mounting nut and rotate it counter-clockwise. When the unit drops down, move it entirely but still close enough, so you can see the rubber gasket while fixing it.
  3. Replace the old gasket with a new one. Make sure that the new gasket is installed securely at the lips and stays flat.
  4. Pick up your garburator unit from the sink to check if it’s positioned flat before locking it back into the place securely.
  5. Inspect if the three mounting grooves are locked in tightly.
  6. The last step in fixing a garbage disposal leak is to connect the drain back again, plug the cord and check if there is still any leak happening.

Garbage Disposal Leak from the Bottom

If there is a leak from the bottom part of your garburator unit, the cause is most likely to be the garbage disposal itself. There is the possibility of a busted seal in the internal part that wears out due to usage or overtime.

Unfortunately, the only possible way to fix a garbage disposal leak from the bottom is to get a new unit. Doing replacement of the garburator is probably your best bet unless your old unit is still under warranty because the fixing is near impossible at this point.

Even though it is hard to notice the leak until there is a formed foul puddle under the sink, there are plenty of solutions available if you can notice before the garbage disposal leak from the bottom problem becomes larger.

The first step you can do, which is the most important, is to determine where the leak occurs. Finding where it’s occurring might be as simple as observing the sink component often.

Doing this independent troubleshooting can save you cost before you replace the entire unit.

Garbage Disposal Leaking From Reset Button

If you find the garbage disposal leaking from the bottom screw, there is an issue with the reset button. It is widespread if the system is fairly old.

You may want to invest in the new replacement, instead of spending out the money to fix it and find out there will be another problem within a couple of months.

Read also : How to Reset a Garbage Disposal

Garbage Disposal Leaking from Reset Button

If your unit is quite new, however, having it repaired might be a better choice. It is also a good thing to do if the unit is under warranty. Ask the company or technician about fixing a garbage disposal leak and preventing the issue in the future.