You may have any issue with your fan in the bathroom. Well, a fan has a significant function to make sure the room does not have mold. Moreover, it controls and sends out the humidity and moisture through ventilation.
The problem is your bathroom does not have an attic. In this case, you may ask how to install a bathroom fan without attic access. The answer will be explained in the following list.
How to Install a Bathroom Fan without Attic Access
Table of Contents
The attic is the space above your room. People use this area for several functions, such as storage, ventilation, and safety support. With the attic, the fan will go out through this spot then lets the moisture goes away directly.
On the other hand, no attic bathroom means installing a bathroom exhaust fan with attic access from the below direction. The task is quite simple as long as you know the basic system and configuration.
Size and design
You may install a new fan because the old one is broken or no longer in good condition.
The first thing you should do is to adjust the size and design. For a new house, the spot for a fan is already available with a specific size. For replacing the old one, you can buy the same size or even the smaller fan. The situation is different if you redecorate the bathroom.
In general, a fan must have similar or less size. The bigger one is out of option because you must adjust it. From this point, you know how to install a bathroom fan where one does not exist is much the same compared to replacing the old one.
The next step related to how to install a bathroom fan without attic access is ventilation. It is the part where you must check properly. A fan is connected to the duct and vent out the excessive moisture.
After removing the old fan, clean this section, you may need to see the building plan to know the duct and ventilation system.
Electrical and wiring system
The next step is the electrical and wiring system. The latest technology creates simplicity for operating bathroom fans. You can see the electrical wiring that connects between a switch and a fan.
Before installing the new one, make sure this part is completely down and recheck it twice. In fact, you should cut the wire off temporarily.
Placing the fan
The next step is to put a fan directly. Solidify and strengthen it with a screw. You should put the box properly and carefully. Make sure you are at the right height to avoid imbalance. This part is necessary when you ask how to vent a bathroom with no outside access.
Patching the ceiling
The last step is to patch the ceiling. If the new fan has the same model and size, the ceiling will look exactly similar to the old one. However, you can add extra patching surrounding the outer section of the fan. It will tighten the fan, and you will not see any gap at the edge.
After you know how to install a bathroom fan without attic access, the next step is the final check. Activate the electricity, and see if the fan can move properly. You can do checking before patching the ceiling.